Average Reviews:
(More customer reviews)At first I wanted to install this in my laundry room - it's in the basement and we always seem to leave the lights on. BUT it's a long, narrow room - and also has the main AC ductwork. Unfortunately the ducts, combined with the lights being too close to the sensor precluded this. The instructions require 3' from any fluorescent ballast, 4' from incandescent fixtures, and 4' from HVAC diffusers - so the laundry room was out. The rest of the basement has some pretty low ceilings (7 ft,) so it was off to the garage. It's installed close to the spot where the stairs meet the garage - one set down, one going up. There was also a convenient open box where I could install the sensor.
It resembles a smoke-detector, and is about the same size. The cover twists off to reveal the sensors and two dials (adjusted with a standard screwdriver - time and light.)
Now when I enter the garage, on go the lights - no more worrying about turning them off. Since my workshop is off the garage, I'm passing through the garage several times per day - and I often forget to turn off the lights (or I'm just too lazy.) Since it's a 2 1/2 car garage, there are several fixtures.
I considered putting the sensor in the workshop, but it's a really dusty environment (woodworking) - it may have worked, but did not want to try it.
So why 4 stars? Well, the instructions are minimal - I could not find any additional instructions online. Little mention of suitable environments (dust, for example) - this made installation trickier than needed.
Also one suggestion - before you install it, remove the cover and check the sensor in the middle - looks like a micro-chip. When I first opened it, there were a couple of largish plastic pieces static-clinging to it. This covered about 30% of the sensor. I'm sure this would have effected the gadget "seeing" me in the room.
As for mounting / installing? Four wire-nuts and two screws was all it took. So why did I look for instructions. Simple questions I had (perhaps overthinking?) - Could I use this and still have a light switch? What about with a 3-way light switch? That kind of thing.
Click Here to see more reviews about: Leviton ODC0S-I1W Self-Contained Ceiling-Mount Occupancy Sensor and Switching Relay 1000,- Watt 120V
The Leviton ODC0S-I1W Ceiling-Mount Self-Contained Occupancy Sensor is the cost-effective choice for commercial and institutional spaces where traditional ceiling-fixture installation is difficult, inconvenient, or costly. Ideal for storage areas, small bathrooms, copy rooms, mop/sink closets, or small spaces without wall switches, this self-contained sensor will help reduce energy costs and it does not require an external power pack and will help reduce energy costs.
ODC0S-I1W Ceiling-MountOccupancy SensorAt a Glance:
No comments:
Post a Comment